Bearings that show wear may not always need to be replaced. Depending on the degree and type of wear, they may be candidates for reconditioning, a process that restores bearings to like-new specifications and performance - at an average 50 to 60 percent of the cost of replacement.

We are pleased to present our first annual Engineering Showcase, a celebration of some of the leading products and companies in mechanical power transmission. In the pages that follow, you’ll find examples of engineering excellence and technological know-how in the field of gears, drives, couplings, machine parts and other mechanical components.

The complete technical Calendar from the February 2014 issue of Power Transmission Engineering.

This paper outlines the design considerations that go into construction of a drive system in order to explain the importance of specific data, why it is required, and where design freedom is necessary. Apart from loads and speeds, interface dimensions and site specific conditions are also needed. Deciding up front which gear rating practice to select can affect the torque capacity of the drive train by ~15%.

Involute splines are commonly used in gearboxes to connect gears and shafts, especially when high torque is transmitted through the coupling. The load is shared among multiple teeth around the coupling circumference, resulting in higher load capacity than a conventional single key. However, the total load is not equally shared among all spline teeth, mainly because of pitch deviations resulting from the manufacturing process. The load distribution along the spline engagement length is also nonuniform because of tooth misalignments and shaft torsional effects. This paper presents an investigation of the influence of spur gear loads on the load distribution of spline teeth.

A brief overview of the induction motor, including the basics of construction, performance and variable speed drives.

The complete Product News section from the December 2013 issue of Power Transmission Engineering.

A discussion of the basics in DC drives, DC motors, AC drives, AC motors and synchronous motors.

Dave Soma, the mechanical supervisor at Leland Olds Station, a coal-fired power plant near Stanton, North Dakota, says he and his maintenance team care deeply about keeping the plant running and providing people electricity, especially in the dead of winter.

The complete Industry News section from the August 2013 issue of Power Transmission Engineering.