Custom PEEK Compounds have led to the development of transmission seals and thrust washers that offer lower wear, friction and temperature advantages.

Latest Sealing Technologies Offer Optimum Wear and Frictional Characteristics.

Equipment downtime and reduced component life are a few of the consequences — and potential costs — of using the wrong seals on many types of industrial equipment including pump bearing frames, electric motors, fans, pillow blocks, gearboxes and more. However, if correctly specified and installed, seals provide effective barriers that both retain lubricants as well as protect against water, corrosion, debris and other contaminants.

conveying system on the varnishing line for a manufacturer of high-end kitchen cabinets were leaking. Oil was dripping on the cabinet parts — ruining the finish. Why were half of the gearboxes leaking?

The improvement of the energy efficiency of industrial gear motors and gearboxes is a common problem for many gear unit manufacturers and end-users. As is typical of other mechanical components, the radial lip seals used in such units generate friction and heat, thus contributing to energy losses of mechanical systems. There exist today simulation tools that are already helping improve the efficiency of mechanical systems — but accurate models for seal frictional losses need to be developed. In this paper SKF presents an engineering model for radial lip seal friction based on a physical approach.

For either brand-new motors or those already in service, "best practices" means that informed technicians can make use of the latest diagnostic techniques (vibration analysis, thermography, shaft-voltage testing, etc.) to prevent electrical bearing damage -- either at the very beginning or very quickly thereafter. If done correctly, the work need only be done once.

The following news items offer the latest on lubrication and seal technology in the power transmission market. From bearing greases to high-performance seals, these products will help extend the service life and manufacturing capabilities for a wide range of industrial sectors.

Seal design engineers and end users are continually seeking improved sealing systems and materials. This paper describes the potential of a new thermoplastic polyurethane (TPU) material to deliver improvements in pressure, speed and temperature capability, which are presented as comparisons to proven industry standard materials. Performance is demonstrated by virtue of test bench results of seals made from MDI-, PPDI- and NDI-based materials.

In an industrial application, equipment uptime is vital for on-time performance and profitability. The rotating members of industrial machines are subject to the highest degree of wear and are more susceptible to failure than non-moving parts. Bearing surfaces are the most critical and often the most expensive portion of the rotary assembly; it is imperative to protect these components. The primary protector of these components is the industrial seal.